Rover V8 Rocker Covers/Camshaft/Timing Chain
|
Page Contents
 Rocker
Covers
Camshaft
Camshaft
Components
Timing
Chain
Rocker Covers
Rocker Covers - singles;
 SD1/TR8
-
Grey
Painted
 
RH - (1) - ERC262
LH - (1) - ERC263
Unpainted
RH - (1) - ERC2990
LH - (1) - ERC3932
Range
Rover -
Early
Models - curved top
RH - (1) - RTC2350
LH - (1) - ETC8604
1986
onwards
Curved
Top
RH - (1) - ETC8681
LH - (1) - ERR7356
Flat
Top
RH - (1) - ETC8680
LH - (1) - ETC8679
1992
onwards
RH - (1) - ERR7363
LH - (1) - ERR7360
Series
2 Range Rover
RH - (1) - ERR7367
LH - (1) - LDR000200
Rocker Covers - pairs;
Unpainted - (1) - RB7431
Powder
Coated -
Black - (1) - RB7431RPCBLACK
Red - (1) - RB7431RPCRED
Gasket - rocker cover;
Standard - (2) - GEG436
Uprated (rubber) - (2) - GEG436UPRATED
Screw - rocker cover retaining;
All
models except Series 2 Range Rover.
Long - (4) - 603127
Short - (4) - 602530
Series
2 Range Rover (8mm spline head) -
Long - (4) - ERR7371
Short - (4) - ERR4818
Spring Washer
- rocker screws - (8) - GHF331
Not
Series 2 Range Rover.
Flat Washer -
rocker screws - (8) - GHF300
Not
Series 2 Range Rover.
Rocker Cover
'T' Bolts - chrome - (2) - RB7440
American
style rocker cover hold down bolts, supplied in sets of 4 (2
sets required).
Breather/Flame Trap;
Right
hand rocker cover (flat top EFi), where fitted.
Original - (1) - RB7432
Short Type - ½ original size - (1)
- RB7432LOW
Powder
Coated -
Black - (1) - RB7432PCBLACK
Red - (1) - RB7432PCRED
Chrome - (1) - RB7432C
Breather
Grommet (pair) - (1) - RB7432ZGROMMET
'O' Ring/Seal
- flame trap - (1) - 564258
Oil Filler Neck;
Threaded Type (where fitted) - (1)
- ERC2989
Screw-On Type - (1) - ERC1208
Retained
by screws. Range Rover only.
Series 2 Range Rover Type - (1) - ERR7335
Gasket - filler neck;
Screw-On Type - (1) - 612819
Series 2 Range Rover Type - (1) - 564258
Oil Filler Cap;
Orange Type - (1) - 625038A
Pressed Steel Type - (1) - 598231
Series 2 Range Rover Type - (1) - ERR5218
'O' Ring/Seal - filler cap;
Orange Type - (1) - 564258
Series 2 Range Rover - (1) - ERR5219
Breather
Filter - efi models - (1) - ERC3209A
Rear
of LH rocker cover.
Cap -
breather filter (efi) - (1) - ERC3208A
Plug Lead
Retainer (where fitted) - (2) - 603672
Holds
4.
Camshaft
We stock a
full range of Standard camshafts, which
represent good value for money. In addition, we offer a choice
of Performance camshafts - available either
as complete kits or on their own - which are designed to
improve torque and horsepower when fitted to standard or
uprated engines.
Our Mild
Road camshaft gives a noticeable increase in low rev
torque, with smooth idle characteristics and good fuel
economy.
The Mild Road
is a hydraulic camshaft, available on its own or as part of a
kit, including followers, single valve springs and fitting
instructions.
Fast
Road camshafts are available separately as a
hydraulic type only, or in complete kits as hydraulic or solid
camshafts. All Fast Road camshafts are suitable for engines
right up to 5.2 litres. They are particularly effective when
used as part of a complete Performance package with our Stage
1, 3 or 4 cylinder heads, uprated fuel systems and Sports
Exhausts.
Fast
Road Hydraulic is a hydraulic camshaft which boosts
top-end power whilst retaining low-end torque and good fuel
economy.
Fast
Road Solid is a solid-lifter camshaft available only
as a complete kit, which includes lifters, adjustable timing
chain set, adjustable pushrods, all necessary gaskets and full
instructions. The Fast Road Solid camshaft is designed for
serious performance applications, where maximum top-end power
is required, whilst still being suitable for the road.
All parts
listed are suitable for saloon/Sports and 4x4 applications
unless otherwise stated.
Camshaft Only - standard;
Saloon/Sports Applications - (1) - ERC2003A
Carb
& efi.
Note: Some
later Rover Vitesses, notably twin plenum models, were fitted
with alternative camshafts, double valve springs, larger
diameter rocker shafts and adjustable rocker gear. These parts
are now generally unavailable but may be replaced using parts
listed below.
Range
Rover - 1970 to 1986
Low Compression Engines - (1) - ERC2003A
Compression
ratios: 8.13, 8.25, 8.5:1.
High Compression Engines - (1) - ETC6849
Compression
ratio: 9.35:1.
Range
Rover - 1986 onwards
Carburettor
Engines
Low Compression - (1) - ERC2003A
8.13:1.
High Compression - (1) - ETC6849
9.35:1.
Efi
Engines
3.5 Litre - (1) - ETC6099
3.9 Litre - (1) - ERR5924
4.2 Litre - (1) - ERR5924
Series
2 Range Rover
4.0 Litre - (1) - ERR3720
4.6 Litre - (1) - ERR4946
Camshaft Only - performance;
Mild Road - (1) - RB7444KENT
Straight
swap for standard cam. No machining required.
Use
also anti pump-up followers ERC4949HD and single springs
RB7454.
Fast Road - (1) - RB7445KENT
Machining
required to valve guides and spring platforms.
See
Camshaft Kits if fitting without modified heads.
Installation
Kit - camshaft - (1) - RB7488
Less
cam. Includes standard timing chain, timing cover gasket &
oil seal.
Suitability:
All engines except Series 2 Range Rover.
Camshaft Kits
Standard
Suitable for
all engines except Series 2 Range Rover.
Kit 1 - (1) - RB7125
Includes
ERC2003A cam & 16 standard followers.
Kit 2 - (1) - RB7489
Includes
ERC2003A cam, 16 standard followers, timing chain, timing
cover gasket & oil seal,
2
x rocker cover gaskets, inlet manifold gasket & 2 x inlet
manifold seals.
Performance
We offer two
Performance cam kits: a hydraulic cam kit and a solid lifter
cam kit. Both kits are complete and a simple job for the
competent DIY mechanic and both offer a worthwhile performance
gain, either on their own or with our Performance cylinder
heads.
Suitable
for all engines except Series 2 Range Rover.
Fast Road Hydraulic - (1) - RB7442HYDRAULIC
Kit
includes special grind hydraulic cam, 16 performance
followers, adjustable timing chain set, all necessary gaskets
& full instructions.
Fast Road Solid - (1) - RB7442SOLID
Kit
includes special grind solid cam, 16 solid lifters, adjustable
timing chain set, adjustable pushrods,
all
necessary gaskets & full instructions.
Camshaft
Components
Gasket - inlet manifold;
All
engines.
Tin - (1) - ERC3990
Composite - (1) - ERR7306
End Seal - manifold gasket;
For Tin Gasket - (2) - AJM645
For Composite Gasket - (2) - ERR7283
Clamp - end
seal - (2) - 602076
Screw - end
seal clamp - (2) - 602236
Cam Follower - hydraulic;
Standard
Each - (16) - ERC4949A
Set of 16 - (1) - ERC4949AKIT
Heavy
Duty
Designed
to resist 'pumping up', extending maximum revs.
Each - (16) - ERC4949HD
Set of 16 - (1) - ERC4949HDKIT
Cam Lube - (1)
- RX1358
Essential
when installing a new cam & followers.
Timing Disc
(protractor) - (1) - RX1359
Pedestal
Shims - (1) - 603734SHIMS
Includes
three sets of shims of different thickness.
Use
to set 'lifter preload' when fitting non-standard components
eg. cams with higher lift than standard.
Cam Bearing
Set (engine block) - (1) - RTC5918A
Woodruff Key - camshaft;
Early Engines - (1) - 90602025
Pre
1976.
All Other Engines - (1) - ERC2838A
Thrust Bolt -
camshaft - (1) - 602227UR
Replaces
the standard (imperial thread) camshaft retaining bolt.
Abutting
the inside of the timing cover, this Teflon-topped bolt
prevents excessive camshaft endfloat.
Timing Chain
All parts
listed are suitable for saloon, sports and 4x4 applications
unless otherwise stated.
Timing Chain - all engines;
Standard - (1) - ERC7929A
Adjustable Kit - (1) - RB7449
Includes
vernier camshaft sprocket, crank sprocket and double roller
chain. Also includes timing protractor and Allen key.
Fully
adjustable cam sprocket allows extremely accurate timing
whilst eliminating stretch common in original parts.
Instruction
included.
Replacement
Chain - double roller - (1) - RB7450
Camshaft Sprocket - standard chain;
All
Engines up to Series 2 Range Rover
Standard (nylon teeth) - (1) - 610289A
Vernier Type (steel teeth) - (1) - 610289VERN
Series 2 Range Rover only - (1) - ERR5086
Crankshaft
Sprocket - all engines - (1) - 90602372A
Spacer - camshaft;
Mechanical Fuel Pump Engines - (1)
- 602149
All Other Engines - (1) - ERC2839A
Not
Series 2 Range Rover.
Distributor Drive Gear - camshaft;
Early Engines - (1) - 602159
Pre
1976.
All Other Engines - (1) - 614188A
Not
Series 2 Range Rover.
Washer -
camshaft - (1) - ERC6552A
All
engines except Series 2 Range Rover.
Bolt - camshaft;
All
engines except Series 2 Range Rover.
7/16"
UNF x 1 1/8"
Standard - (1) - 602227A
Thrust - uprated - (1) - 602227UR
Prevents
excess cam endfloat.
M12 x 30mm - (1) - ERC5749
Alternative
- metric.
Flanged Bolt
- camshaft (M10 x 30) - (1) - FS110301L
Series
2 Range Rover.
Thrust Plate
- camshaft - (1) - ERR2609
Series
2 Range Rover.
Cam Retaining
Collar - (1) - ERR5926
Series
2 Range Rover.
Screw -
thrust plate - (2) - SH505061
Woodruff Key - camshaft;
Early Engines - (1) - 90602025A
Pre
1976.
All Other Engines - (1) - ERC2838A
|
Cotizacion Inmediata -Catalogo Master
Precios - 85.000 Repuestos LR
Despachamos a Domicilio al Interior en 24 Horas
LISTAS de PRECIOS
-
PUBLICADAS ONLINE en US$ 
Land Rover Group
